Originally Posted by bass7858
Good day Brethren. I am making a uds using the bottom half of a cheap kettle as the dome lid. Had to fashion a ring for it to rest on as it was way smaller then the open drum.
I hear people mention gaskets and silicone in use for sealing such cracks or voids and am just wondering if brethren could post pics of the actual product or products they used.
The only hi heat silicone i can find is automotive. is this the stuff i want or is their another variety.
any advice or suggestions appreciated
I had a gap between my drum and my weber extension ring for the rotisserie setup. I found a Big Green Egg replacement gasket which run about $20. It's a sticky back gasket that I just ran around the ring and it filled the gap perfectly.