View Single Post
Unread 02-10-2012, 06:54 PM   #88
Triple T BBQ
Full Fledged Farker
Join Date: 12-20-11
Location: SE, Minnesota
Downloads: 0
Uploads: 0
Thumbs up More progress!

You have been waiting all week for this......

Yep, here we go again!

Mock up of the fender cut out on the plasma cutter.

Need to raise the fender up a bit so it aligns with the top of the rail of the trailer.
It turned out pretty good we think.

The reverse flow plate is installed and we have the tuning plate build for the end of the pit. In addition to the firebox inlet and exhaust stack plates, we should have a lot of control over the heat, smoke, etc.

Another view of the tuning plate and drain.

Getting close. Almost ready to fire things up and do a test burn.

The wood and large item storage box is finally done.
Triple T BBQ - CBJ 2012-2014 [url][/url]
Triple T BBQ is offline   Reply With Quote

Thanks from: --->