You know you have been checking and waiting for it.
HEHEHE Here we go!
Got the fenders framed out. The front toolbox has also been started. We also finished the front brackets for the stainless steel shelving unit.
Note the tail light cut outs. The firebox got the vents put in today and the door stops are now welded into place.
The new master cylinder has been bolted on and the trailer tongue shortened. Ran out of steel till sunday so the storage and wood box will have to wait a bit.
Got the chimney stub ground down and welded into place. It lets us remove the 5ft tall six inch chrome stack when we are traveling to and from events.
Inside view of the stack. Made it so the insert will be able to be dropped down near grate level or up depending on the amount of smoke control or draw I want in the smoker.
A close up view of the brace and upper tube. The inner tube will slide up inside the fixed one and then be adjustable with the bolt and wing nut.
A close up photo of the vent. Also moved the original bracket on the right rear side of the firebox to the back to match the original one. And the door didn't cost 600 bucks extra either.