View Single Post
Unread 02-03-2012, 03:30 PM   #9194
kmcrane
Found some matches.
 
Join Date: 01-25-12
Location: Pasadena, TX
Downloads: 0
Uploads: 0
Default picked up my drum and some plumbing odds and ends today

I picked up my drum today to begin my UDS build. I am in the process of rinsing out with dish soap and water before i begin the beheading process. I also stopped by home depot and picked up my pipe nipples and caps. I still need to get to harbor freight to pick up my one inch ball valve (considerably cheaper than home depot especially with the 20% off and free multimeter. My Old Smokey lid fit pretty good, does need a little fine tuning but not bad for now. This is going to be a fun build.
Attached Images
File Type: jpg UDS In Progress.jpg (52.9 KB, 676 views)
kmcrane is offline   Reply With Quote