View Single Post
Unread 01-30-2012, 09:25 PM   #69
Triple T BBQ
Full Fledged Farker
 
Join Date: 12-20-11
Location: SE, Minnesota
Downloads: 0
Uploads: 0
Default

More progress:

Took in the local boat show this last weekend. Saw another trailer with the same backlit setup. Going to have to add this to the trailer now for sure.




Finished the doors, hinges, and inner straps to help seal the doors. They turned out pretty good I think.




Another shot of the doors. By friend burned out the inside with his rosebud torch.


Picked up a used aluminum truck box for the storage unit for now. It was too cheap to pass up and only weighs about 30lbs!





Made some more measurements and we are ready to trim the trailer tongue and setup the tongue for the new master cylinder.




Another shot of the hinges and doors. Turned out pretty good I think.




A nice shot of the fender and inner panel. This should help keep the heat from the smoker and firebox off the trailer tires. Also a nice front shot of the disk brakes.



Another side shot of the trailer with the toolbox.

__________________
Triple T BBQ - CBJ 2012-2014 [url]http://www.bbq-brethren.com/forum/showthread.php?t=123061[/url]
Triple T BBQ is offline   Reply With Quote


Thanks from: --->