View Single Post
Old 12-06-2011, 07:36 AM   #3
Full Fledged Farker
Join Date: 01-13-10
Location: Charlotte, NC

I use a short piece of 1" square tubing with some slots cut into the top of it that I attatch the factory clip to since the clip will not fit on my grates. This leaves the probe about 1 1/2 inches off the grate. I have an off set and drilled holes in the back of the tank for the probes to slide through, this keeps them out of the way when opening the main door. There is a shelf on the back to hold the bases.
crb478 is offline   Reply With Quote

Thanks from:--->