View Single Post
Old 11-17-2011, 10:38 PM   #8890
On the road to being a farker
10_Bears's Avatar
Join Date: 10-06-11
Location: Melbourne, Australia

Question regarding exhaust stack, like an exhaust tip on a car.

How do I fit one to the large bung hole? Do I need to weld one on or is there pipe that screws in I can buy? I'm sure the thread is NPS, just not sure how available this thread would be on a pipe.

Any suggestions would be much appreciated. Ideally I'd like to use a chrome exhaust tip.
10_Bears is offline   Reply With Quote