View Single Post
Old 08-30-2011, 09:35 PM   #12
is Blowin Smoke!
Pappy's Avatar
Join Date: 05-09-11
Location: Granite City, Illinois (Near St. Louis "GO CARDS")

Originally Posted by pman777 View Post
8ea 1/2" holes are sufficient for the top exhaust. I haven't done the math but I imagine the 8ea 1/2" holes are a comparable surface area to 3ea 3/4" holes.

I do know that one Weber vent has 4ea 7/8" holes. I did the math on this and I know the 4ea 7/8" holes is a larger surface area than Norco's suggested 8ea 1/2" holes.
Again I was mistaken. I thought people were using eight 1" holes instead of 1/2". That would be much less. Right now I'm just toying with the idea of weber 2 vents.
22.5 WSM, 120 Gallon Offset, Weber Performer, IQ-110, ET-732
Pappy is offline   Reply With Quote