View Single Post
Old 08-17-2011, 09:34 PM   #8476
Full Fledged Farker
brewerjamie15's Avatar
Join Date: 08-16-10
Location: Milwaukee, WI.

Worked on the UDS again today. Not too long though, added the nipples into the holes ( I used 3/4" close) added the elbow for my "up pipe" thingy.
Finalized the green paint, pulled tape from the portions that will be painted gold.
Put another coat of paint on the lid.
The intakes went in quite tightly. As a matter of fact, I had to file out the holes a little bit.
Instead of a 7/8" hole saw I'd use 1" if I were to make another UDS. Even though the nipples were tapered, they were a struggle to get in.


Has anyone tried to use JB Weld to better adhere the intakes on the inside of the drum? I'm going to try it. I don't want the intakes loosening up and paying a welder costs more than an attempt at JB Weld. (package says it'll hold to 700 degrees F)
UDS, Weber Performer, 18" Weber Silver, and a Smokey Joe. (I have a human-child too)
brewerjamie15 is offline   Reply With Quote