View Single Post
Unread 06-29-2011, 02:38 PM   #1
Pappy
is Blowin Smoke!
 
Pappy's Avatar
 
Join Date: 05-09-11
Location: Granite City, Illinois (Near St. Louis "GO CARDS")
Downloads: 0
Uploads: 0
Default Maverick et-732 probe location on a uds

I built a UDS with a weber lid and need to know where you drilled your holes to pass the probe & wire to the inside of the UDS. Do you use the probes on the bottom rack or top, if you have meat on both racks? What size hole do you drill? I'm not crazy about dropping the probes through the vent holes in the weber lid. I was wanting to work on this later tonight if anyone has pictures or other posts or suggestions. Thanks
__________________
22.5 WSM, 120 Gallon Offset, Weber Performer, IQ-110, ET-732
Pappy is online now   Reply With Quote