Originally Posted by Spicy-Meat
Nice work Philip. Looks great. What did you use for the probe inserts?
I used 1/2" electrical water-tight for UF cable connectors. Took the rubber insert, five of them actually, made a silicone mold without the thru-slot for the wire and then cast them with high temp silicone with a small thru-hole that I pushed the sensors through.
If there's interest in them, I can run do them from time to time. 24 hours cure per casting.
I use casting materials fairly often so I had the materials here to do it with and I was looking for a way to prevent air from going through the hole.
A few photos below.