View Single Post
Unread 05-10-2011, 06:10 PM   #21
JMSetzler
Babbling Farker
 
Join Date: 04-25-11
Location: Valdese, NC
Downloads: 0
Uploads: 0
Default

My DigiQ DX arrived today. I was disappointed to find out that the sensor grommets I purchased aren't going to be helpful with the DigiQ probes. The pit probe has the alligator clip which won't fit through the grommet and the temp probe would have to be straightened out a bit to make it fit through. Not a real big deal, but it does put me back to square one with a solid method to run the probes into the WSM. I'm not against the idea of drilling a hole in the smoker door panel... One of the photos posted in this thread appears to have the probes running into one of the holes where a sensor grommet would fit, but there is actually no grommet installed. It looks like the original nut and bolt are just removed. Would this be the best way to route these probes?
__________________
Kamado Joe Jr. Kamado Joe Big Joe Kamado Joe Classic Old Country BBQ Pits Brazos Offset
UDS Traeger Lil' Texas Elite
JMSetzler is offline   Reply With Quote