View Single Post
Unread 04-13-2011, 03:10 PM   #1
Take a breath!

Theboz1419's Avatar
Join Date: 08-13-09
Location: Elgin, IL
Downloads: 0
Uploads: 0
Default Whats good to protect a deck from heat.

Since, we had a little, but very dangerous burn through on our deck from a UDS, not being properly closed off at a end of a smoke(not myself).

I was looking at getting .5 to 5/8 Cement board and then tiling it with a outdoor tile and then putting the UDS on top while still using fire bricks to keep an air gap between the UDS and the tile.

Would this work or is there a better alternative besides moving the UDS off the Deck.
Raspberry PI Heatermeter homemade temp controller, 2 UDS.
New Version 4.2 Heatermeter with K thermocouple support Available
PM me, if you would like a heatermeter pre-made, everything included, heatermeter, case, blower, SD card programmed, servo and case, no soldering needed ready for your network and BBQ.
Theboz1419 is offline   Reply With Quote