View Single Post
Unread 01-06-2011, 03:36 PM   #7336
SmokerKing
is one Smokin' Farker
 
SmokerKing's Avatar
 
Join Date: 09-07-10
Location: Sunny AZ
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by zwylde1 View Post
For the holes in the bottom for the pipe nipples is there any reason why a 1" hole saw can not be used versus the "step bit" alot seem to use?
I've used the hole saw and unibit methods. Hole saw is a PIA compared to the unibit IMO.

The Unibit works great. If you stop at the right step on the bit, you can thread the nipple right into the drum. ( I still tack weld it on the inside)
SmokerKing is offline   Reply With Quote