View Single Post
Unread 11-13-2010, 10:10 AM   #16
is one Smokin' Farker
Join Date: 09-30-09
Location: Memphis
Downloads: 0
Uploads: 0

Originally Posted by colonel00 View Post
Looking good. Did you have to grind down the lip of the "bottom" for the weber lid to fit without alteration to the lid? I have started a similar build with the "top" of the drum at the bottom and cut out the bottom. I did have to grind down the lip of that drum a bit though for the weber lid to fin just right.
Luckily for me I have the luxury of walking the warehouse with my weber lid and test fit. Thanks to the good folks over at here in Memphis. I grab the one that fits best. My last build with a weber lid I had to grind a hair off the crimped edge.

My first build was with a Kingsford lid and I lucked out.
UDS', mUDS, COS. Weber gasser & kettle. Thermapen,Digiq2, Golden-Tiger
jetfxr27 is offline   Reply With Quote