View Single Post
Unread 08-23-2010, 06:13 AM   #33
DaveMW
is One Chatty Farker

 
DaveMW's Avatar
 
Join Date: 07-31-10
Location: Livngston, Montana
Downloads: 0
Uploads: 0
Default

The entire grill is now touched up where rust was showing, handles are done so I moved on to the vents. The vents were a mess. It seems like there were times when this grill was used and then let sit out with the lid off allowing the rain to mix with the ash and run out the bottom vents. The effect is that the ash dried and hardened on the vents like concrete. With that said I ended up sanding the vents with 220 grit sandpaper. Admittedly this left the vents scratched but I felt they looked better with some scratches than they did with ash adhered to the metal. Here is a side by side, one cleaned and one as I found it.
Attached Images
File Type: jpg Grill Vents.jpg (30.2 KB, 509 views)
DaveMW is offline   Reply With Quote