View Single Post
Unread 08-16-2010, 03:24 PM   #8
chilidic
Found some matches.
 
Join Date: 07-02-10
Location: Englewood, Florida
Downloads: 0
Uploads: 0
Default

Here's a recipe I found on another site, not mine by any means I believe the originator is Habanero Smoker. I've used this a dozen times now and it makes fantastic pastrami.


CURE
1 Tbsp Morton Tender Quick (or Basic Dry Cure) per pound 1/2 Tbsp dark brown sugar, packed per pound
1/2 Tbsp freshly ground black pepper per pound
1 tsp granulated garlic powder per pound
1 tsp ground coriander per pound
Directions:
  1. Trim surface fat of an untrimmed brisket flat to 1/8”, this is important so that the cure fully penetrates the meat; yet it leaves enough fat to keep the meat moist. If you do a whole brisket or thicker cut of meat, you will need to prepare a wet cure and inject the meat.
  2. In a small bowl, mix Morton Tender Quick, sugar and remaining ingredients. Mix all ingredients well, making sure to break up any lumps of sugar, no matter how small. I found that the bare hands work best. Rub mixture into all sides of brisket, and work it in well (do not shake off any excess that is on the meat). I prepared a 5 ½ pound half flat (point end), used about ¾ of the mix, and the meat was fully cured.
  3. Next place brisket into a two gallon Ziploc bag; expel as much air as possible, and make sure the seal is secure. Refrigerate and allow to cure 4 days, turning the brisket over every 12 hours, or at least daily. After 4 days of curing, remove the brisket from the bag, and thoroughly rinse under cold running water. After rinsing, place the meat in a container and cover with cold water. Let the meat soak for 30 minutes, change the water, and let soak for another 30 minutes. This helps reduce the saltiness from the meat. Pat dry with paper towels and apply rub.
    • If your brisket weighs 7 pounds or more, or if it is under 7 Dry Rub Ingredients:
      • 3 TBS. coriander seeds (4 TBS. if you don’t have white peppercorns).
      • 2 TBS. black peppercorns
      • 2 TBS. yellow mustard seeds
      • 1 TBS. white peppercorns
      • 2 TBS. of granulated garlic
      Makes enough rub for one brisket flat.

      Directions:
      1. Combine the first four ingredients, and coarsely grind in a spice grinder or coffee grinder. Pour ground mixture into a bowl, add the granulated garlic and remix. Apply the dry rub to the brisket generously, working the rub into the meat by pressing it in with the palms of your hands. Air dry in the refrigerator for 4 to 8 hours before before placing it in the smoker.
      2. Remove brisket from the refrigerator and place it on a tray, fat side down, and place in a pre-heated Smoker, at 220 degrees F. Apply 3 hours of smoke. I used 2 hours of pecan, and finished with 1 hour of apple. Cook until the internal temperature reaches 160 – 165 degrees F. You can also use a smoking temperature of 250 degrees F.
      3. When the brisket reaches an internal temperature of 160 – 165 degrees F, take it out of the smoker. Wrap the brisket in one layer of heavy-duty aluminum foil. Wrap it in a towel, and place it fat-side up in a cooler or microwave oven for two hours (if just going into the microwave you don't need the towel). Remove brisket from the cooler (or microwave) and remove the foil and save. Wrap brisket in plastic wrap, and then wrap it in the foil you just saved. Place in the refrigerator for at least 1 day, two is better. When ready to eat thin slice the pastrami across the grain for a tenderer slice. You can either eat it cold or warm it up.
chilidic is offline   Reply With Quote


Thanks from: --->