View Single Post
Old 03-18-2010, 05:30 PM   #5643
Full Fledged Farker
Join Date: 12-15-09
Location: Antelope, CA (Sacramento metro area)

Originally Posted by NASCARican View Post
I've seen builds where people use high temp caulk on the lid, then put cookie sheet (wax paper) around the ring and squeeze the lid down on it and let it set might be worth a try! :/
That's a good idea! The only concern I'd have is that the lid might end up fitting TOO well. ;-)

Here's something else that might work:

1/4" thick x 1/2" wide adhesive-backed silicone foam good for 500 degrees (the adhesive is good for that temp too). Rather expensive at $24 for 15', but it may work well. Probably a bit to dense to take up more than about .01" of warpage though...

Just a thought...

Char-Broil Commercial Series Gasser, ECB, MECO 4400 charcoal grill, 22.5" OTS, UDS built 3/20/2010 ([URL=""]Pics[/URL], [url=""]Video[/url])
Maverick ET-7 and ET-73, home-built 18A sous vide temperature controller
IMBAS Certified MOINK Baller
My blog: [url=""] THINK + CREATE + EAT[/url] - [URL=""]"Like" on Facebook[/URL]

[B][COLOR=red]"Meat: It's what's for dinner. And lunch, breakfast, dessert..."[/COLOR][/B]
Rodney is offline   Reply With Quote