View Single Post
Unread 02-03-2010, 02:30 PM   #4898
somebody shut me the fark up.
Mark's Avatar
Join Date: 08-13-03
Location: St. Peters MO
Downloads: 0
Uploads: 0

Originally Posted by crappiemike View Post
My first UDS. I got the barell from a place that refinishes them,no liner.I welded a 1/8 by 3/4 inch band of steel around the top inside edge leaving 1/2 inch sticking up to fit the Weber lid. I welded the entire wheel assembly from a Weber to the bottom. I made a 2 inch id carburator style air intake,works well. The grill supports are 1 1/2 inch pieces of angle weled to the barell. Thanks for all the tips on this forum..Here's a link to some pictures...
So should we refer to you as crappie or mike for short?

Anyway, way to go on your steel band modification. That's the way to do it.

As far as the air inlet, it looks a little difficult. I have previously offered a simpler but similar means for providing inlet air via the attached pictures. Has anyone else ever tried this approach? Yeah I know; not enough wheels
Dr. Mark (STL)
Ph.D. (honorary) Bovine $hitology

A thin line separates paranoia from an acute understanding of reality.

Last edited by Mark; 02-26-2010 at 01:49 PM..
Mark is offline   Reply With Quote