View Single Post
Unread 02-03-2010, 01:23 PM   #4895
crappiemike
Found some matches.
 
Join Date: 01-26-10
Location: Ham Lake,Mn
Downloads: 0
Uploads: 0
Default Smoker #1

My first UDS. I got the barell from a place that refinishes them,no liner.I welded a 1/8 by 3/4 inch band of steel around the top inside edge leaving 1/2 inch sticking up to fit the Weber lid. I welded the entire wheel assembly from a Weber to the bottom. I made a 2 inch id carburator style air intake,works well. The grill supports are 1 1/2 inch pieces of angle weled to the barell. Thanks for all the tips on this forum..Here's a link to some pictures...http://picasaweb.google.com/mikehanson0/Uds
crappiemike is offline   Reply With Quote


Thanks from:--->