View Single Post
Unread 10-05-2009, 07:56 PM   #4288
Smokin' D
is One Chatty Farker
 
Join Date: 12-11-07
Location: N. Andover, MA
Downloads: 0
Uploads: 0
Default

Quote:
Originally Posted by biggs98 View Post
Anyone using the 3/4 pipe nipples as intakes w/conduit nuts having trouble threading them all the way through? ( no access to welder) I even tried threading 1 all the way through before installing but couldn't get the other one to thread to the drum. Any suggestions? Thanks
I'll try to help. The short, full thread nipples are slightly tapered from the center down to the end so it is not possible to run a nut all the way across them. What I did is to thread a conduit nut onto the nipple as far as it will go. Then install the nipple from inside the barrel and thread another nut on from the outside. I used a pair of vise grips attached to the nipple to keep it from turning as I tightened the outer nut. You could install the nipple from the outside and turn on the other nut from inside the barrel but that is really cumbersome and it's quite tight quarters!
Smokin' D is offline   Reply With Quote