Chicken and Ribs
Hey I'm still not that good at figuring out the amount of each meat selection I need to cook when a customer orders a two meat gig.
I have a request for ribs (spares st. luey style) and pulled chicken for 50 folks.
How many slabs and how much chicken would you figure for this gig.
Party is 90% adults who 70% of will probably want ribs, 20% chicken and 10% both.
Are you doing whole chickens or pieces? I did a gig for 125 last month and did 150 pieces of thighs and had about 25 pieces left.
WHen I do ribs I figure that 1 rack of spares will feed 2-3 people if I'm dealing out the ribs at 2-3 bones a piece depending on the rack. So if your getting your ribs from Sam's in the 3 pack, your going to need at least 6 packages if not 7 to be on the safe side.
I'm sure others will give their advice , but if it was me doing the gig this is what I would plan. Hope this helps.
Count on 10-12 bones per slab. Chix, just decide on the pieces you want to cook and what you expect each customer to consume, this goes for the ribs too.
Iffin it were me, I'd do 7 racks and chix thighs and breast (1 chix per). Of course you have discussed this with the client or have experienced them before. YMMV
|All times are GMT -5. The time now is 02:36 PM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vBulletin Optimisation provided by vB Optimise v2.6.0 Beta 4 (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.