As the title says that's my intention. It stands about 5' tall 3' wide and I have to put hinges on the door. Planning on using dowls for racks and hanging. My question is about venting. Can I just put in a piece of pipe like I did with the UDS. advice in getting enough air and venting would be appreciated. I am going to use AMZEN smoker pellet tray. Thanks for your help in advance.
11-15-2013 07:27 AM
All depends on how you are going to fire it. Tell us more.
11-15-2013 07:46 AM
I built mine with 2 sliding vents in the door, one low and one high. I use a smoke generator for it. I also put a large plexiglass window in the door so I can see what's going on inside. Works great.
11-15-2013 10:43 AM
Build a firebox on the outside with cement building blocks against the box on one side and vent the back into the wooden structure. If you have an overhang on the roof, drill some 2 inch holes under the overhang for exhaust. Make sure the firebox is long enough that the fire is not too close to the wooden wall to catch it on fire. Smoke away and enjoy your own smoked bacon!
11-15-2013 01:46 PM
If using the A-Maze-N smoker you just need air in and out
Use a brick or cinder block to set the A-Maze-n on
I got a couple of floor heat registures from home depot for inlet and outlet. Plenty of air and easy damper control
11-15-2013 02:10 PM
I figure I could Place one register on top and one toward the bottom of the box. airflow in and out. I think it would work. Thanks