The BBQ BRETHREN FORUMS.

The BBQ BRETHREN FORUMS. (http://www.bbq-brethren.com/forum/index.php)
-   Q-talk (http://www.bbq-brethren.com/forum/forumdisplay.php?f=5)
-   -   Rec Tec and GMG metal thickness? (http://www.bbq-brethren.com/forum/showthread.php?t=174943)

CtTradArcher 11-09-2013 05:47 PM

Rec Tec and GMG metal thickness?
 
I am considering getting a pellet cooker and pretty much have it narrowed down to a GMG or a Rec Tec. Considerations were features, cost, and financing.

I went and looked at the GMG grills today and was surprised on how thick the metal was, or should I say wasn't. They also had Traeger and Louisiana grills and they too were of the same thickness. They had a Memphis there that was definitely thicker, but 2 1/2 times the cost, which I cannot justify.

I cannot see a Rec Tec, so I don't know how they stack up. Does anyone know the gauge of the metal vs GMG?

I am liking the features of the GMG over the Rec Tec, like the remote and the meat probe. But from what I can tell from what I have read here, Rec Tec owners are pretty happy people. But then again, so are the GMG folks.

So I guess if the metal of both are of similar thickness, I will go with the GMG.

Sorry for the long winded post. Just hoping to get some input from those in the know.

Thanks!

nucornhusker 11-09-2013 09:39 PM

Yoder uses thicker steel than all of the above, and is still in that price range, just a little higher. Have you looked into them?


All times are GMT -5. The time now is 06:56 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vBulletin Optimisation provided by vB Optimise v2.6.0 Beta 4 (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
2003 -2012 BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.