-   Q-talk (
-   -   UDS Temp probe location (

Mbrienzo 05-09-2013 06:56 PM

UDS Temp probe location
Was wondering where everyone will put there probe at on the grate. Do you put it in the center? May main concern is if I am doing just 1 piece of meat I want to put the meat in the middle but then my probe is off to the side. Can I clip it to th grate on the Nader side. Will I get false readings with the meat dripping on it? Just curious.

Pappy 05-10-2013 06:07 AM

I wouldn't want gunk dripping on the probe. I would have it near the meat, but not too close and keep it clean.

jmoney7269 05-10-2013 06:24 AM

I have a 2" machine screw welded to the bottom of my grate, I clip my probe to it right below the meat. Works perfect. Juices on the probe wire don't matter 1 bit. It's BBQ not a beauty pageant, your gonna get stuff dirty.

All times are GMT -5. The time now is 08:21 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
2003 -2012 BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.