-   Q-talk (
-   -   Need help!!!! (

georgiasmoke 04-27-2013 10:46 PM

Need help!!!!
I've got a barrel that I received from Line-X that had Component B or Polyol in it previously. I've did a pressure wash and a 600+ degree burn for 4 hrs. I've heard some ppl say that Polyol is mainly vegetable oil but I am not sure. Has anybody else gone through this? And if so, do I have anything to worry about? Thanks.

MisterChrister 04-27-2013 11:20 PM

As long as you get it burned and brushed down to bare metal you'll be fine.

martyleach 04-27-2013 11:20 PM

Do you have bare metal on the inside now? I have had drums with liners that had hydraulic fluid in them. After filling with water and cutting the lid off I burned them from the outside with a Harbor Freight weed burner (Propane tank) till the steel was red. This burns the liner and nasties on the inside. I then pressure wash and if necessary grind till clean. Pain in the drain!!!

georgiasmoke 04-28-2013 08:12 AM

Yes it is bare metal. Even after I pressure washed it, it looked brand new on the inside.

All times are GMT -5. The time now is 05:01 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
2003 -2012 BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.