-   Q-talk (
-   -   Cracked Weld (

Faston 03-23-2013 08:07 PM

Cracked Weld
Well I tried to slide my smoker over by pulling on the angle iron :( (used for the cooking grate). Only the weld to firebox weld cracked everything is still in perfect alignment

This smoker is very heavy and I do have a low trailer. Would a inexpensive MIG welder from harbor freight be sufficient to fix the weld.
Any other suggestions?


colonel00 03-23-2013 08:17 PM

Can you snap some pics of where the issue is? Hard to completely understand from your description. Is the weld structurally integral or is it just a joint?

HookedOnQ 03-23-2013 08:23 PM

I would prolly try to find a local welding shop and have them fix it if u dont have access to a good mig or stick welder if its as heavy as u make it out to be im sure it made of some pretty thick gauge steel therfore i doubt that a harbor freight mig would do a very good job i have never used one but have used some other no name mig welders and i wasn't very impressed at all..

Faston 03-23-2013 08:51 PM

Thanks guys,
I will try to get some pics in the morning.

BigBellyBBQ 03-24-2013 02:38 PM

if you dont have experience, do your self a favor, degrease and wash the area and stop by a local shop....cleaned the trick..and roll back down the road...

All times are GMT -5. The time now is 02:26 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
2003 -2012 BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.