-   Q-talk (
-   -   1st H&F Brisket, Am I OK? (

dwfisk 03-03-2013 10:30 AM

1st H&F Brisket, Am I OK?
Been reading what the brothers have been saying so I'm trying a hot & fast brisket cook in my reverse flow stick burner. Been cooking on the high side of 300*, about 310*-325*. 13 pound brisket has been in about 1 hour & 45 minutes and come up from 77* to 117*, 40* in the last 45 minutes. The probe is in the thick part of the point. For an old low and slow guy this is a little scary. Should I slow it down? Any thoughts or advice?

Vision 03-03-2013 10:34 AM

You're good if you usually temp in the point. For HnF you're a little's usually 325-350.

dwfisk 03-03-2013 10:38 AM

I usually temp in the thick end? Is there a better way?

Bludawg 03-03-2013 10:43 AM

You really don't need a thermo. Wrap it in Butcher paper at the 4 hr mark and cook it to probe tender another hr to hr&half normally. The point is going to get done sooner than the flat concentrate on the flat either in temp or probing yo get the flat right the point will take care of it's self.

dwfisk 03-03-2013 10:47 AM

Thanks Bludawg, that is my plan, just using the temp as a security blanket. Just never done it this way before.

HeSmellsLikeSmoke 03-03-2013 11:00 AM

If you follow Bludawg's advice, this won't be your last H&F brisket. :becky:

dwfisk 03-03-2013 11:07 AM

Thanks Jim. Got my BP ready. Think I'll grab a beer and try to be patient.

All times are GMT -5. The time now is 06:20 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
2003 -2012 BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.