-   Q-talk (
-   -   One issue I have with the OTG... (

ColdFyre 02-09-2013 05:15 PM

One issue I have with the OTG...
Heat rises... darnit.

It's just not big enough for me to lay down 2 racks of ribs. I have 'em on end in a rib rack and the tops are getting burned.

Gauge at the top is reading 310 but my probe at grate level is 242.

Result? Burned edges! Still a few hours left to go too

(the more 'mahogany' ones on the right are crisping up cuz I marinated 'em in some teriyaki sauce last night. I'm guessing the sugar is burning. The two racks to the left (not the single one to the far left, that's a tester) are just have Montreal on 'em and aren't nearly as dark on the tips)

ColdFyre 02-09-2013 05:22 PM

Don't get me wrong.... still the best purchase I made last year :)

HeSmellsLikeSmoke 02-09-2013 05:52 PM

Well, it is primarily a grill, not a smoker. I never have the coals directly under meat when I set up for indirect.

I am not sure how you are set up there? Perhaps you are asking too much of it?

ColdFyre 02-09-2013 06:06 PM

Yeah.. I know it's a primarily a grill. One of these days I'll graduate to an offset, WSM or drum of some sort. I got this one cuz of it's versatility. Didn't wanna buy one that could only do one thing just to come to realize I hated doing it :)

My coals are shoved to one side, as usual. Got the snake method going. Bad camera angle in that shot. Foil is under the meat to catch the grease. Here's a pic pre-meat.

Bludawg 02-09-2013 06:08 PM

Those bones look done to me, You can rotate the ribs in the rack every so often. I haven't used a rib rack in a very long time IMO they'e a useless piece of equipment like a BCC gizmo and charcoal holders.

ColdFyre 02-09-2013 06:23 PM

bones on top are pulled back nicely but the ones on the bottom arn't... gonna be pulled here in a few minutes. I'm hungry!

Racks are nice if I wanna do more than 7 ribs.

Untraceable 02-09-2013 06:24 PM

Buy a wsm and never look back. Except then the last rib on each end will be burnt

J'ville Grill 02-09-2013 06:34 PM

1 Attachment(s)
OK you've got the OTG now get the Cajun Bandit conversion kit for it.
Attachment 75632

Sent from my iPhone using Tapatalk

silverfinger 02-09-2013 06:37 PM

Use a rib rack. This will allow you to cook at least 3 racks and brings your ribs just that much farther from the heat. It works, I've done it. Keep your temps down to 220. And only get just a couple briquets going. They will slowly spread evenly. The bottom vents, only leave open an 1/8 inch and adjust your heat from the top. Hope this helps.

Q-Dat 02-09-2013 06:54 PM

Find yourself an 18" by 3" deep cake pan and a braising pan rack from restaurant suppy that will fit the pan. Bend the legs so that it sits half way off the bottom of the pan. Burn your charcoal(preferably in some type of basket) under the pan which is filled with water to about a half inch below the rack. Only light 2-3 coals to start and run the kettle with the vents wide open. I never check the temp. They are usually done somewhere between the 4 and 5 hour mark.

3rd place ribs at a 50 team contest a while back using this method. It is a pain toclean the pan and rack, but it makes awesome ribs every time.

Carbon 02-09-2013 08:14 PM

Kind of a hassle but you can stack them tandem and keep rotating them every few minutes.

dadsr4 02-10-2013 10:15 AM

Weber kettle second cooking grate

dadsr4 02-10-2013 10:23 AM

Raise charcoal grate on Weber Kettle?

All times are GMT -5. The time now is 06:07 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
2003 -2012 BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.