Rebuilding my Smoker
I have doing quite a bit of reading on a better designing a better Smoker.
I have what would called a Homemade Offset, Reverse flow smoker.
It started life as a pair of steps.
And it turned into this.
Now I do plan to add some angle iron to the firebox and tighten it up quite a bit.
I am kicking around some other ideas.
What would you do to improve this?
I have found some latches that will hold the door much tighter.
I also am looking at a DigiQ system.
Now that's what I call up-cycling. Nice work. :thumb:
|All times are GMT -5. The time now is 12:35 PM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vBulletin Optimisation provided by vB Optimise v2.6.0 Beta 4 (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.