The BBQ BRETHREN FORUMS.

The BBQ BRETHREN FORUMS. (http://www.bbq-brethren.com/forum/index.php)
-   Q-talk (http://www.bbq-brethren.com/forum/forumdisplay.php?f=5)
-   -   Length of wood slats on Weber 1000/1100 swing up table? (http://www.bbq-brethren.com/forum/showthread.php?t=149882)

Nerd 12-20-2012 07:44 PM

Length of wood slats on Weber 1000/1100 swing up table?
 
Brothers,

I'm making new wood parts for my Father-in-law's old Weber Genesis 1000 as a Christmas gift. He loves that grill, but the wood parts are looking worse for wear. I measured the dimensions for most of the pieces on my own 1000, but mine was purchased 2nd hand without the swing up work table, so I don't have dimensions for it.

I would be forever grateful if one of you could measure the length of the slats on your swing up work table and post them here so I can make them correctly. The table looks to be the same on both the 1000 and 1100.

Sadly, time is of the essence as I would like to have them largely completed before he arrives in two days to avoid making up excuses for long absences in the garage while he's here.

Gratefully Yours,
Sean

swamprb 12-21-2012 01:35 AM

I'll go out to the back 40 tomorrow and take a measurement of the ones I have in my boneyard. I do know that there are at least 2 types of bracket holder designs.

swamprb 12-21-2012 11:04 AM

15.5" x 1.5"

Nerd 12-21-2012 01:30 PM

Perfect! Thanks a million and have a great holiday season!


All times are GMT -5. The time now is 01:15 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vBulletin Optimisation provided by vB Optimise v2.6.0 Beta 4 (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
2003 -2012 BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.