Replaced the Annoying Alligator Clip on Guru (pics)
I know a lot of BWS owners like to place the smoker temp probe on the Tel Tru stem using the Guru supplied alligator clip. But at least for me, it seems that if I just looked at the clip wrong, it would pop off the stem. So I decided to come up with an alternate mounting method.
I measured the stem and it is approx 1/4" in diameter. I bought a bag of 3/16" sprong clip tool holders from McMaster Carr (part #1722A41, 10 for $5.40). I then drilled a hole through the clip to accommodate the temp probes for both my Guru and ET732. I did have to squeeze the clip a little tighter with pliers to keep it firm on the Tel Tru stem. I think this will work pretty good.
Nice job, good mod.
|All times are GMT -5. The time now is 04:27 AM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vBulletin Optimisation provided by vB Optimise v2.6.0 Beta 4 (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.