The BBQ BRETHREN FORUMS.

The BBQ BRETHREN FORUMS. (http://www.bbq-brethren.com/forum/index.php)
-   Q-talk (http://www.bbq-brethren.com/forum/forumdisplay.php?f=5)
-   -   UDS top not a circle (http://www.bbq-brethren.com/forum/showthread.php?t=123207)

Sammy_Shuford 12-30-2011 11:17 PM

UDS top not a circle
 
Well, it's a bit out of round. I wonder if I squeeze it if I can get it to hold shape?

Anyone else had this problem?

AustinKnight 12-30-2011 11:31 PM

The top lip of the barrel or the lid, I had both were i had to get pliers and bind the lip out on some sides and I used a brick on the ground and placed my lid center with the brick and pushed down on the sides. That worked for me now it closes down properly to preserve coal.

Sent from my SGH-T959 using Tapatalk

Sammy_Shuford 12-30-2011 11:40 PM

Thanks,

BigBobBQ 12-31-2011 02:56 AM

if it is the top of the barrel that is out of round I used a small piece of cable and wrapped it around the top and used a small turnbuckle like thing to tighten it down and it pulled it back to a round shape.

ssbbqguy 12-31-2011 07:09 AM

Just lay it on it's side and gently push on a soft surface. I check every one I assemble for roundness and it's a common problem. It will affect temp. variences and should be round. Steve.


All times are GMT -5. The time now is 01:04 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vBulletin Optimisation provided by vB Optimise v2.6.0 Beta 4 (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
2003 -2012 BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.