UDS Back from the sandblaster....
Hello all, newb to the max here. Just got the uds back from the sandblaster. And I was wondering.... Do I need to prime it? I plan on using high temp paint or engine paint... Thanks in advance..
|
I would prime it.
|
UDS Back from the sandblaster....
You don't have to prime it, but it will make the paint stick and last longer. Just be sure the primer is high temp too.
|
Thank a lot... Looks like ill be priming and painting this weekend...
|
Not sure how well it works as I'm in the process of building my UDS. But I just primed my Weber lid with the VHT Flame Proof primer from AutoZone. I scuffed the lid with my angle grinder and a wire wheel. I tried a bunch of stuff to try and get the porcelain coating off and it wouldn't budge. We'll see what happens. Painting will only be as good as your prep work. Here is a pic of it all primed.
http://i1122.photobucket.com/albums/...psc1ad6fe0.jpg Chad |
Quote:
|
Quote:
http://www.vhtpaint.com/products/flameproof/ Of course after reading the product page above, I'm not sure how well it's going to hold up. I might try and figure out away to heat it up tomorrow. Chad |
All times are GMT -5. The time now is 08:30 PM. |
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
2003 -2012 © BBQ-Brethren Inc. All rights reserved. All Content and Flaming Pig Logo are registered and protected under U.S and International Copyright and Trademarks. Content Within this Website Is Property of BBQ Brethren Inc. Reproduction or alteration is strictly prohibited.