jtcannonball
Knows what a fatty is.
I have read a lot on here prior to building my first smoker. I've finished the mods on my Jumbo Joe and my pot is being delivered by next week off of eBay. I'll build my basket this week and pick up the remaining parts.
Question #1
I notice that Air flow on the bottom vent jumbo Joe is ok but needs a mod like a can with holes on the sides to keep ash from clogging the vent during a cook. I'm wanting to add a ball valve for easier temp control while cooking and for adding a Guru later on. Is one 3/4" valve enough or should I add two?
Question #2
I'm wanting a Tel Tru Therm to go under my middle grate. What length stem would you recommend? I'm wanting the BQ300.
One last question.
Grommet hole for meet probes? Any good recommendations?
Thanks a ton.
jtcannonball
Question #1
I notice that Air flow on the bottom vent jumbo Joe is ok but needs a mod like a can with holes on the sides to keep ash from clogging the vent during a cook. I'm wanting to add a ball valve for easier temp control while cooking and for adding a Guru later on. Is one 3/4" valve enough or should I add two?
Question #2
I'm wanting a Tel Tru Therm to go under my middle grate. What length stem would you recommend? I'm wanting the BQ300.
One last question.
Grommet hole for meet probes? Any good recommendations?
Thanks a ton.
jtcannonball