PDA

View Full Version : Operation Manual on Remote Set of Tiger


woodpelletsmoker
08-04-2012, 12:45 AM
http://www.allchinas.com/probe/tiger3.jpg
Remote Set of Tiger

Press "on/off" button to turn on or off the power of the REMOTE SET
Press "AUTO" to select automatic mode or manual mode
When Manual model, press "+" or "-" to adjust speed of fan manually
Press "PIT" to program PIT temperature, time interval, H/L temperature Alarm
Press "MEAT" to program MEAT temperature, time interval.
Use "UP ^" or "DOWN V" buttons to inrease or decrease value
Press button of "C" or "F" to select your display
Press "UP ^" button, you will find window of Energy Management, press "DOWN V" button to SHADOW "Open", Press "UP ^" button to normal dispaly. then the remote set will be on battery saving mode. The power on remote set will be off a short time later and natutally the alarm will be disabled in remote set.
Press "UP ^" button, you will find window of Energy Management, press "DOWN V" button to SHADOW "Close", Press "UP ^" button to normal dispaly. then the remote set will be on all the time. Alarm will be activated.

Common Errors are mostly caused by
LOW voltage/Low Amps on the controller or the remote set

One buyer sent back WOLF. I check it and every thing is in good order.
Checking with buyer, he used a battery from a notebook. It is 12 VDC but only 500 ma. WOLF needs 2000 ma.

One buyer of Tiger reported no communication between remote set and the Tiger. I asked hm to check battery on the remote set. After changing new battery, it works!